top of page
Materials
Anchor 2
Soldering the Clearomizer
Use a dremel to enlarge one of the holes on the clearomizer.
Run the red wire through the hole, and solder it to the top of the little cylinder inside.
Black wire get soldered, then hot glued, then wrapped in electrical tape on the outside of the clearomizer.
Tip:
Tin the wire, and tin the little nub. I solder this directly to the top of the little circle.
Helpful:
This step. Felt. Impossible.
I added hot glue at the very bottom of the cavity after soldering the red wire, so that the tube would be added right on top of the hot glue and the soldered wire.
Hot glue to the very top of the clearomizer.
Soldering
Miss Boof Cosplay
bottom of page